FLIR CM85 | True RMS clamp meter (current clamp with integrated multimeter) for 600 A with METERLiNK and with traceable NIST calibration certificate.
Industrial-grade clamp meter with sophisticated functions for current analysis and troubleshooting in inverter-controlled drives.
The industrial-grade FLIR CM85 current clamp is specially designed for complex fault diagnosis with high-quality current analysis functions. These include harmonic mode to find noise from different electrical sources, rotating field mode to check the phase sequence of three-phase systems for easier diagnosis of motors and installations, and starting current mode to detect transients caused by power-on processes. The FLIR CM85 is also equipped with filtering for inverter-controlled drives to analyze non-sinusoidal waveforms and noisy signals in variable speed drives. This simplifies the localization of electrical problems in complex industrial and commercial systems.
Features and highlights:
- In VFD mode, the variable signal frequency is processed accordingly by filters and the exact frequency and voltage values are measured. This is important for service and repair work.
- Transfer of the stored measured values via Bluetooth
- MeterLiNK® technology allows the measured values to be transferred directly to the images taken by a FLIR thermal imaging camera.
- The CM83 is connected to compatible mobile devices via Bluetooth using the "FLIR Tools Mobile" application.
- Bluetooth range: maximum 10 m
- Analog bar display of the measured values
- Power and power factor measurement
- True RMS measurements of alternating voltages and alternating voltages with a direct component
- Large, easy-to-read display, 10,000 counts
- Additional lighting from a bright white LED in the display ensures good reading even in dark Clearing
- Automatic AC/DC detection even at maximum current of 600 A
- Automatic AC/DC detection even at maximum voltage of 1000 V
- Automatic resistance, continuity and diode test detection
- Measurement of the harmonic component / distortion up to the 25th order
- Indication of phase rotation
- Resistance measurement up to 100 kΩ
- Frequency measurement
- Capacitance measurement
- Holding of the last measurement
- Peak value measurement and storage
- Measurement of inrush currents
- Zeroing for DC currents
- Storage of maximum, minimum and average value
- VFD mode - low pass filter
- Detector for detection and display, if there is no contact
- Automatic switch-off of the device when not in use
- Clamp opening: 37 mm for 31 mm cable
- Withstands a fall of 1.2 m
- Safety category: CAT IV-600V, CAT III-1000V
- Overvoltage category: IEC 61010-1 CAT IV-600 V, CAT III-1000 V, IEC 61010-2-033.
- Specified temperature range from 18 °C to 28 °C with specified accuracy: 0.2 * (accuracy)/°C
- Dimensions: (H × W × L): 49 mm × 100 mm × 262 mm
- Weight 590 g with batteries
Scope of delivery:
- 6 AAA batteries
- Instruction manual / CD
- CAT IV silicone test cable
- Limited Lifetime Warranty
- with traceable NIST calibration certificate