Keysight N9913A | FieldFox handheld HF combi analyzer 30 kHz to 4 GHz, USB 2.0, LAN, battery
Manufacturer number: N9913A
On Request
Keysight N9913A | FieldFox high frequency combi analyzer 30 kHz to 4 GHz.
Cable and antenna analyzer (CAT) and vector network analyzer (VNA)
- 30 kHz to 4 GHz
- Dynamic range: 100 dB
- Output power level +1 dBm
- CAT: cable loss, reflection loss, distance to the fault
- VNA: Measurement of S parameters: S11, S21, S22, S12 according to amount and phase
Spectrum analyzer:
- 5 kHz to 4 GHz
- ± 0.5 dB amplitude accuracy over the entire bandwidth and over the entire temperature range from -10 ° C to +55 ° C. Same accuracy class as with laboratory equipment
- Signal to noise ratio ≥105 dB
- The accuracy is achieved without warm-up time and temperature fluctuations have no influence on the specified accuracy
- Tracking generator over the entire bandwidth
Independent source, vector voltmeter (VVM), power meter and other integrated measurement options:
- RF source: 30 kHz to 4 GHz, CW, CW coupled and tracking
- VVM: 30 kHz to 4 GHz, comparative phase and electrical cable length
- Power measurement by a USB power sensor: 9 kHz to 24 GHz (depending on the type of sensor used)
- Integrated power meter 5 kHz to 4 GHz
- Optional GPS receiver
- Optional: Variable DC voltage source 1 V to 32 V, 650 mA max and 8 W max
General characteristics:
- Quick-Cal: integrated calibration routines - no calibration components are required
- CalReady: integrated test connection for S-parameter determination and for error distance measurement in cable measurements
- InstAlign: The accuracy is achieved without warm-up time over the entire frequency range and temperature fluctuations have no influence on the specified accuracy
- Built-in GPS receiver to assign the measured values to geographic coordinates
- Battery operating time 3.5 hours
- Operating temperature range: -10 ° C to 55 ° C
- Weight 3.0 kg
Typical areas of application:
- In mobile communication within a cell for cable and antenna testing
- Monitor the RF spectrum and for interference analysis
- Active and passive component and module test
Designed for rough use:
- Enclosed housing, dustproof, without fans etc.
- Water repellent; resists salty and moist influences
- Meets MIL-PRF-28800F Class 2
- Meets MIL-STD-810G, Method 511.5 Procedure I conditions for use in potentially explosive atmospheres (type test)
Description
N9913A | FieldFox handheld HF combi analyzer 30 kHz to 4 GHz, USB 2.0, LAN, battery
The fast Feld-Fuchs N9913A from Keysight is a mobile handheld device for rough field use for testing cables and antennas . Optionally, it can be expanded to a spectrum or network analyzer - hence the name "Combination Analyzer". With this device you hold Keysight - quality and accuracy in your hands - because it is portable, lies well in the hand and is easy to use.
Other optional expansion options are e.g. B. the installation of an integrated power meter, an independent signal generator, a vector voltmeter, an interference analyzer, a variably adjustable DC voltage source, and a GPS receiver.