Keysight N2893A | Clamp, BNC, 15 A DC - 100 MHz, AutoProbe
Manufacturer number: N2893A
On Request
Keysight N2893A | Current clamp 15 A, DC - 100 MHz for oscilloscopes with AutoProbe Interface.
- large bandwidth range from 0 to 100 MHz
- high signal-to-noise ratio with the ability to detect even small currents
- Peak current 15 A, direct current 15 A, alternating current 10 arms, short-term maximum peak current 30 A.
- a protective device prevents high overload
- Automatic demagnetization and calibration eliminates residual magnetization and unwanted DC voltage offsets
- To use this power source on the 80000 and 90000 series oscilloscopes, the E2779A power supply and the high-impedance adapter E2697A must be used.
- For the Keysight 90000X series, the N5449A high impedance adapter must be used.
- has a high-impedance AutoProbe interface for connection to the Keysight oscilloscopes
Documents & Downloads
Description
N2893A | Clamp, BNC, 15 A DC - 100 MHz, AutoProbe
The Keysight N2893A active current probe offers a bandwidth from 0 to 100 MHz and is intended for the Keysight (formerly Agilent's electronic measurement technology) oscilloscopes of the Infiniium and InfiniiVision series. It also features low noise of <2.5 mArms and low distortion. Automatic demagnetization and calibration eliminates residual magnetism and unwanted DC offsets.
The power supply for the current probe, which has an AutoProbe connection, takes place directly via the Keysight oscilloscope series InfiniiVision and Infiniium.
An ideal area of application for this current clamp is the detection of current transients, which are typically found in motor control units, switched power supplies, inverters and current amplifiers that drive inductive loads.
News and Knowledge
Navigating through the range of available specifications, options and capabilities can be challenging. There are a lot o...