Keysight N2876A | Probe, Passive 100X, 1.5GHz, BNC Read Out
Manufacturer number: N2876A
On Request
Keysight N2876A | Passive probe, 100: 1, 1.5 GHz, readout.
- Bandwidth 1.5 GHz
- Input capacitance 2.6 pF
- Input resistance: 5 kΩ when the probe is connected to an oscilloscope input with 50 Ω
- Attenuator ratio 100: 1
- maximum input voltage: 21 V CAT I
- Cable length 1.3 m
- BNC connection with readout
- ideal in combination with Keysights (formerly Agilent) InfiniiVision and Infiniium oscilloscopes
Technical Data
Documents & Downloads
Description
N2876A | Probe, Passive 100X, 1.5GHz, BNC Read Out
The passive Keysight (formerly Agilent's electronic measurement technology) probe N2876A offers a bandwidth from 0 to 1.5 GHz and an attenuator of 100: 1 and is especially intended for use in measurement in fast digital circuits in order to be able to assess pulse edges. This probe requires a 50 Ω input impedance from the oscilloscope.
The small diameter of the probe tip of 2.5 mm, the small input capacity and the large number of accessories, especially for small pin spacings, make it ideal for measurements on ICs or surface-mount components (SMD). The sharp tip is designed with a spring so that it is held in the middle of an IC connector by a special insulated holder, which prevents a short circuit to neighboring IC pins. Special adapters for good ground contact are also available.
This probe is ideal for all Keysight InfiniiVision and Infiniium oscilloscopes (formerly Agilent's electronic measurement technology) with a 50 Ω input resistor. This probe can be used especially for testing on 50 Ω conductor systems and on signal sources with a low internal resistance of <50 Ω.