Go to homepage
  Quickly and Easily Request a Quote!
  Free Shipping for Orders higher than 50€!
  Independent Consulting!

Produktvergleich 0

Shopping Cart
Show all categories Network Analyzers Back

PICOTEST J2120A | Line injector, 10 Hz - 10 MHz

Manufacturer number: J2120A

PICOTEST J2120A
PICOTEST J2120A
PICOTEST J2120A
PICOTEST J2120A
PICOTEST J2120A
PICOTEST J2120A
PICOTEST J2120A
PICOTEST J2120A
Reordered - in stock. Delivery time on request

€541.00

or choose one of the following options:
Product inquiries
Highlights Documents & Downloads Description Related Articles

Independant Consulting

More than 25 strong brands and exclusive partnerships.

About the brands

Services

More than instruments: Before, during and after sales.

Go to the services

Demonstration & Consulting

Sales and technical support close to you.

Start request

Documents & Downloads

Datasheet
pdf | 0.83 MB

Detaildescription

J2120A | Line injector, 10 Hz - 10 MHz

The mains voltage insertion module J2120A allows the voltage to be modulated on the input side of a DC power supply, for example the way it is used to measure a high suppression of noise from the supply voltage (Power Supply Rejection Ratio / PSRR). The injector module must cover a frequency range that lies below the mains frequency up to the bandwidth of the power supply control loop of the power supply under test.

The mains voltage injector module can only supply electricity. Therefore, the output amplitude can be very clearly influenced by the current requirement caused by capacitive loads. The network analyzer Bode 100 from Omicron Lab has a high selectivity, so that distortions at the outlet of the injector do not influence the measurements. Since this injector can only impress low power, the input signal from the oscillator should be kept as small as possible, but above the noise level. As a guideline, the level is below approx. 50 mVss (-20 dBm).

Measurement of the input impedance: This mains input voltage injector can be used in conjunction with a current clamp to measure the input impedance of a power supply. The input impedance of a switching power supply or controller is negative and is therefore a stability challenge when an EMI filter is involved. However, this measurement is important for the design, analysis and for the verification process. The current clamp must be set to 1A / V or the results must be adjusted according to a different scaling.

Accessoires (7 products )

Pico USB vector network analyzer, 300 kHz to 6 GHz, Quad RX
Pico USB vector network analyzer, 300 kHz to 6 GHz, Quad RX
Pico VNA 106 (PQ111)
Delivery time upon request
€6,245.00
PICOTEST INJB01
Bundle
PICOTEST INJB01
Feed Bundle 1 - starter package, signal feed network analyzers
Delivery time upon request
€4,570.00
PICOTEST VRTS1.5
PICOTEST VRTS1.5
Voltage regulator demo board for non-invasive stability measurements with the network analyzer
Delivery time upon request
€137.00
Pico VNA 108
Pico VNA 108
USB vector network analyzer, 300 kHz to 8.5 GHz, Quad RX (PQ112)
Delivery time upon request
€8,355.00
PICOTEST INJB03
Bundle
PICOTEST INJB03
Feed Bundle 3 - Stability, PSRR, Impedance, Signal Feed Network Analyzers
Delivery time upon request
€2,618.00
PICOTEST INJB05
Bundle
PICOTEST INJB05
Feed Bundle 5 - complete package injectors, signal feed network analyzers
Delivery time upon request
€4,844.00
PICOTEST INJB02
Bundle
PICOTEST INJB02
Feed Bundle 2 - without transformer, signal feed network analyzers
Delivery time upon request
€3,809.00

Alternate products (11 products )

PICOTEST J2100A
PICOTEST J2100A
Feed transformer, 1 Hz - 5 MHz
Delivery time upon request
€541.00
PICOTEST J2130A
PICOTEST J2130A
DC bias injector, 10 Hz - 10 MHz
Delivery time upon request
€541.00
PICOTEST J2101A
PICOTEST J2101A
Feed transformer, 10 Hz - 45 MHz
Delivery time upon request
€541.00
PICOTEST J2140A
PICOTEST J2140A
Attenuator, DC - 50 MHz, 10, 20 and 40 dB, 50 ohms
Delivery time upon request
€230.00
PICOTEST J2110A
PICOTEST J2110A
Solid state voltage injector, DC - 40 MHz incl.J2170A power supply
Delivery time upon request
€1,376.00
PICOTEST J2121A
PICOTEST J2121A
High Power Line Injector, 400V / 20A max 100Hz - 1MHz
Delivery time upon request
€2,288.00
PICOTEST INJB03
Bundle
PICOTEST INJB03
Feed Bundle 3 - Stability, PSRR, Impedance, Signal Feed Network Analyzers
Delivery time upon request
€2,618.00
PICOTEST INJB02
Bundle
PICOTEST INJB02
Feed Bundle 2 - without transformer, signal feed network analyzers
Delivery time upon request
€3,809.00
PICOTEST J2113A
PICOTEST J2113A
Semi-floating differential amplifier, ground loop breaker, DC - 800 MHz, incl.J2170A power supply
Delivery time upon request
€1,829.00
PICOTEST INJB05
Bundle
PICOTEST INJB05
Feed Bundle 5 - complete package injectors, signal feed network analyzers
Delivery time upon request
€4,844.00
PICOTEST J2111B
PICOTEST J2111B
Current injector, DC - 40 MHz including J2171A power supply
Ready to ship in 5 to 10 business days
€1,582.00

Recommendations (2 products )

PICOTEST J2180A
PICOTEST J2180A
Ultra low noise preamplifier, 0.1 Hz - 100 MHz, incl.J2170A power supply
Delivery time upon request
€2,288.00
PMK DCB500HZ-8GHZ
PMK DCB500HZ-8GHZ
DC block 50Ohm 500Hz-8GHz SMA
2 in stock. Ready to ship in 1 business day
€390.50

About the Manufacturer

PICOTEST
PICOTEST
Picotest specializes in precision measurement solutions for applications in the power supply industry.
Read more

Last Seen Products

Product added to compare
Product Compare added Product Compare